Reading the key metrics

Win rate, expectancy, observed and adjusted values, profit factor and recommended risk on the analysis page.

All courses · Lesson 1 of 6 · Advanced · 4 min

The analysis page condenses a backtest into a handful of numbers. This lesson explains what each one means, how observed and adjusted values differ, and how to compute a few of them yourself from the trade table so that you know exactly what you are looking at.

Win rate and expectancy

The analysis page lists the number of wins, losses, breakevens and total closed trades, and from them the win rate: the share of closed trades that were wins. It also shows an adjusted win rate, which exists to temper small-sample optimism. The win rate alone says little, because a strategy can win rarely and still be profitable if the wins are large.

The expectancy in R is the average result per trade, measured in multiples of the amount risked. Both an observed value (the plain average of your sample) and an adjusted value are shown. Prefer the adjusted one when the sample is small, and remember that either number carries a margin of error, as the backtesting course explains.

expectancy = average R per trade = (sum of all R results) / (number of trades)
average win = (sum of winning R) / (number of wins)
Both are expressed in R, so strategies with different risk amounts can be compared.

Profit factor and risk sizing

The profit factor is gross profit divided by gross loss: the sum of all winning results over the absolute sum of all losing results. Above 1 means the sample made money before any costs you did not include; 1 means break-even. It is a general metric that you can calculate yourself from the trade table. The analysis page does not display it, so treat it as a cross-check rather than as a number to look up.

The page also shows a recommended risk percentage and an adjusted full Kelly percentage. The Kelly figure is the theoretical risk per trade that maximises long-run growth for a given win rate and payoff; it is very sensitive to estimation error, which is why an adjusted value is shown and why many traders risk only a fraction of it. Treat both as upper reference points, not as targets.

Worked example

Metrics from ten trades

  1. The ten results in R are: +2, −1, −1, +3, −1, −1, +2, −1, +1.5, −1.
  2. Wins are +2, +3, +2 and +1.5, so 4 wins and 6 losses. The win rate is 4 / 10 = 40%.
  3. Gross profit is 2 + 3 + 2 + 1.5 = 8.5R and gross loss is 6 × 1 = 6R. The sum of all results is 8.5 − 6 = +2.5R, so the expectancy is 2.5 / 10 = +0.25R.
  4. The average win is 8.5 / 4 = 2.125R, and the profit factor is 8.5 / 6 = 1.417, about 1.42.
  5. Cross-check: 0.4 × 2.125 − 0.6 × 1 = 0.85 − 0.60 = +0.25R, the same expectancy.

A 40% win rate, +0.25R expectancy and a profit factor of about 1.42, from only ten trades, so every figure is very uncertain.

Edge probability

The analysis page also reports an edge probability. It is a model-based probability of a profitable sample, not the probability that the true edge is positive. In other words, it describes how likely a sample like yours would be to come out profitable under the model's assumptions, which is not the same as saying how likely the strategy is to be profitable in future.

Key takeaways

  • Win rate says how often you win; expectancy in R says what you earn per trade on average, and observed and adjusted values both appear.
  • Profit factor is gross profit divided by gross loss; you can compute it from the trade table, the analysis page does not show it.
  • Recommended risk and adjusted full Kelly are reference points, and the full Kelly figure is very sensitive to estimation error.
  • Edge probability is a model-based probability of a profitable sample, not the probability that the true edge is positive.

Sign in to save your progress and quiz results.